Albany
Soft Sheen Brilliant White 5L

AA0138001F
Quick drying, durable, soft sheen finish for interior walls and ceilings. Resists yellowing and fading.
Soft Sheen Brilliant White
Share...

In detail

Albany Soft Sheen is a low VOC content soft sheen finish. It is a washable product which is thinned with water and is applied by brush, roller or spray. It is suitable for interior use. It is touch dry in 2 hours and recoatable after 4 hours. Soft Sheen emulsion is a decorative coating providing a low sheen finish for use on walls and ceilings.Washable products are ideal for medium traffic areas such as lounges and bedrooms.It can be applied to coated plaster surfaces without thinning. On new plaster, it is ideal to use a thinned first coat of matt emulsion or contract emulsion as a priming coat, prior to finishing with soft sheen emulsion.

Size
5L 
Application Methods
Airless Spray, Brush, HVLP Spray, Roller
Coverage
Up to 14sq/m per litre 
VOC level
Low 
Thinning
Water 
Touch dry
1-4 hours 
Recoatable
1-4 hours 
Scrubbability
Washable 
Colour
Brilliant White 
Colour type
White 
Finish
Soft Sheen 
Cleanup
Water & Detergent 
Base
Water 

* Colours on screen may vary from actual paint

Additional information

Albany Soft Sheen Emulsion is suitable for a wide variety of new or previously painted interior wall surfaces where a subtle soft sheen finish is required.

Preparation
Surfaces must be clean, dry and free from grease or dust. Remove all loose material. Defective paint must be removed and the surface primed if necessary with the appropriate Albany Primer. Glossy surfaces should be thoroughly abraded before application to ensure good adhesion. Avoid the inhalation of dust. Wear a suitable face mask if dry sanding.

Application
  • Please check for colour accuracy prior to application. C. Brewers & Sons is not liable for decorating costs caused as a result of an incorrect colour being applied. Always intermix packs for colour consistency.
  • Stir well before use. Apply by brush, roller or spray.
  • For best results 2 coats are recommended.
  • On new dry plaster or highly porous surfaces, dilute 40% by volume with clean water for first coat only as a primer.
  • Avoid using during periods of high humidity or in temperatures below 8°C.
  • One litre covers up to 14 sq metres depending upon the surface texture, porosity and the method of application.
  • Surface dry in 2 hours. Recoatable after 4 hours.
  • Clean equipment immediately after use with water.

Transportation and Storage
  • Ensure this pack is stored upright and secure at all times. C Brewer & Sons Limited cannot accept liability for damage caused by spillage.
  • Do not store below 5°C or above 40°C.