Albany
Smooth Masonry Paint Colour 5L

AA0647030F
Durable, flexible, smooth, matt finish, weather resistant coating for exterior masonry
Share...

In detail

Albany Smooth Masonry Matt is a low VOC content matt finish. It is a washable product which is thinned with water and is applied by brush, roller or airless spray. It is suitable for exterior use. It is touch dry in 2 hours and recoatable after 4 hours.

Size
5L 
Application Methods
Airless Spray, Brush, Roller
Coverage
Up to 10sq/m per litre 
VOC level
Low 
Thinning
Water 
Touch dry
1-4 hours 
Recoatable
8-12 hours 
Suitable for...
Exterior use 
Scrubbability
Washable 
Lifespan
Up to 10 years 
Colour type
Tinted 
Finish
Matt 
Cleanup
Water & Detergent 
Base
Water 

* Colours on screen may vary from actual paint

Additional information

Albany Smooth Masonry Paint is a durable water borne matt masonry coating. Suitable for exterior surfaces such as concrete rendering, pebbledash rough cast, building blocks and stone. Do not use on common or fletton type brick or engineering bricks.

Preparation
Surfaces must be clean, dry and free from grease or dust. All loose material or defective paint must be removed by scraping and brushing using a stiff nylon brush. All cracks should be cut open. If green algae, moss or fungal growth are present, surfaces must be treated with Albany Fungicidal Wash. Remove dead growth, re-treat with a further coat of Albany Fungicidal Wash if required. Allow to dry thoroughly. Fill cracks with a 3:1 sand/cement mixture and allow to dry out completely. Old lime and chalky surfaces must be treated with Albany Stabilising Solution and allowed to dry for 16 hours before applying Albany Smooth Masonry Paint. Avoid the inhalation of dust. Wear a suitable face mask if dry sanding.

Application
  • Stir well before use. Apply by brush, roller or spray.
  • For best results a minimum of 2 coats are recommended.
  • Avoid using during periods of high humidity or in temperatures below 8°C.
  • One litre covers up to 10 sq metres, depending upon surface texture, porosity and the method of application.
  • On highly textured surfaces the spreading rate may be greatly reduced.
  • Surface dry in 2 hours. Recoatable after 4 hours.
  • Clean equipment immediately after use with water.