Crown Trade
Steracryl Mould Inhibiting Matt Magnolia (Ready Mixed) 5L

AD0153008F
A high opacity anti-mould emulsion for interior walls and ceilings. Washable, stain resistant Matt finish.
Steracryl Mould Inhibiting Matt Magnolia (Ready Mixed)
Share...

In detail

Crown Trade Steracryl is a water-based high opacity mould inhibiting finish for interior walls and ceilings. It contains a fungicide to prevent mould growth. 

Ideal for use in bathrooms and wet rooms where condensation can build and mould form. 

Allow for adequate ventilation during the drying period. Do not apply when air or substrate temperatures are likely to fall below 8°C or when the relative humidity is above 80% during application or the drying period.

Size
5L 
Coverage
Up to 14sq/m per litre 
VOC level
Low 
Thinning
Water 
Touch dry
1-4 hours 
Recoatable
1-4 hours 
Suitable for...
Interior use 
Scrubbability
Washable 
Colour
Magnolia 
Finish
Matt 
Cleanup
Water & Detergent 
Base
Water 

Additional information

For Interior Use
Crown Trade Steracryl Mould Inhibiting Matt provides a Matt finish containing a special blend of fungicides that makes it possible to maintain decorated surfaces in good condition in humid environments. Crown Trade Steracryl Mould Inhibiting Matt is suitable to use in most interior areas likely to be subject to damp and condensation. Paint for professional use only to prevent mould growth on the painted surface.

Preparation
Ensure all surfaces are sound, dry, clean, and free from dirt, oil, grease or other contamination. Remove all loose or flaking material back to a firm sound edge. Avoid the inhalation of dust. Wear a suitable face mask if dry sanding.
Any organic growth must be removed and area treated with Crown Trade Fungicidal Solution. Allow to dry.

Application
Stir thoroughly. Crown Trade Steracryl Mould Inhibiting Matt may be applied by brush, good quality medium pile roller or airless spray.

This product is recommended for use as supplied. However, on new plaster or highly porous surfaces, apply a mist coat of Crown Trade Steracryl Mould Inhibiting Matt thinned with 40% clean water. Follow with 2 liberal coats. For application by airless spray, thin up to a maximum of 10% by volume with clean water. Use 0.013" to 0.015" fluid tip and pump pressure of approximately 2250lb per square inch.

Avoid Overthinning. Do not apply when air or substrate temperatures are likely to fall below 8°C or when the relative humidity is above 80% during the application or drying period.

Spreading Capacity
Approximately 14m² per litre depending upon surface texture and porosity.

Drying
Touch dry in 1-2 hours.
Recoatable after 4 hours under normal dying conditions.

Cleaning
Clean equipment with water immediately after use.

Transportation and Storage
Ensure this pack is stored upright and secure at all times.
Crown Paints Ltd cannot accept liability for damage caused by spillage.
Do not store below 5°C or above 40°C.