Sandtex Trade
Classic Stone Gloss Coloured 5 L

AP116025F
Premium, protective & decorative, gloss finish for exterior use
Classic Stone Gloss Coloured
Share...

In detail

Sandtex Trade Classic Stone Gloss is a low VOC content gloss finish. It is a washable product which is thinned with water and is applied by brush. It is suitable for exterior use. It is touch dry in and recoatable after 6 hours. Water based exterior gloss is a tough, flexible high sheen finish for wood and metal, which is non-yellowing and provides good resistance to knocking, scuffing and weathering.
It can be applied over most previously painted surfaces without an undercoat. On new surfaces apply over the top of a suitable primer and undercoat.

Size
5 L 
Application Methods
Brush
Coverage
Up to 14sq/m per litre 
VOC level
Low 
Thinning
Water 
Recoatable
4-8 hours 
Scrubbability
Washable 
Colour
Titan White 
Finish
Gloss 
Cleanup
Water & Detergent 

* Colours on screen may vary from actual paint

Available colours

Sandtex Trade Classic Stone Gloss Coloured is available in 1131 colours from the Sandtex Trade Colour Cards.


Browse colours

Always ask your client to try their colour choice on the wall first. Colour cards and emulsion sample pots are available at your local Brewers or at designerpaint.com

Additional information

Surfaces
For Exterior use. Sandtex Classic Stone Gloss can be applied to most sound, correctly prepared, exterior masonry surfaces and surfaces previously painted with gloss, emulsion, masonry and cement paints. Sandtex Trade Classic Stone Gloss is not suitable for application to bitumen surfaces or fletton bricks.

Preparation 
New surfaces: New surfaces usually require little preparation. Any faults in old surfaces must be rectified. Particular attention should be given to those which may lead to moisture penetration. All surfaces must be clean, dry and free from anything that may interfere with the adhesion of the materials to be applied. Sound gloss paint should be thoroughly abraded to provide a key. Avoid the inhalation of dust. Wear a suitable face mask if dry sanding.

Loose or flaking material
Remove all loose, flaking or suspect material by scraping or brushing with a stiff bristle brush (not wire).

Organic growth: All organic growth must be removed by scraping or brushing with a stiff bristle brush (not wire) and applying Sandtex Fungicide in accordance with the manufacturer's instructions.

Chalking, Weathered and Porous surfaces
These surfaces should be brushed down and treated with a liberal application of Sandtex Trade Stabilising Solution. Allow at least 16 hours before painting.

Application
Stir well before use. Apply with a Masonry paint brush, an exterior roller or by airless spray. For maximum durability, two coats of Sandtex Classic Stone Gloss is recommended. Do not apply when there is a risk of rain or when air or substrate temperatures are likely to fall below 8°C or when the relative humidity is above 80% during application or drying period.

Properties
Spreading Capacity: 6m²-14m² per litre on rendering. On very textured surfaces e.g. roughcast or pebbledash, coverage will be greatly reduced.

Drying time
Dry and re-coatable after 6 hours in normal drying conditions. 

Cleaning
Wash all equipment with water when changing colours and immediately after use.

Transportation and Storage
Ensure this pack is stored upright and secure at all times. Crown Paints Ltd. cannot accept liability for damage caused by spillage. Do not store below 5°C or above 40°C.