Leyland Trade
Hardwearing Matt Magnolia 5L

AV30179010F
High quality, stain & moisture resisting, matt finish for interior use on walls, ceilings and woodwork. Durable and scrubbable.
Hardwearing Matt Magnolia
Share...

In detail

Leyland Trade Hardwearing Matt is a low VOC content matt finish. A scrubbable product which is thinned with water and is applied by brush, roller, airless spray or HVLP spray. Matt emulsion is a decorative coating providing a flat finish for use on walls and ceilings.

  • Suitable for interior use. 
  • Touch dry in 1-2 hours and recoatable after 4 hours. 
Wipeable products are suitable for light traffic areas where occasional cleaning is required. Can be applied to coated plaster surfaces without thinning. On new plaster, thin the first coat with water to manufacturers recommendations.

Size
5L 
Application Methods
Airless Spray, Brush, HVLP Spray, Roller
Coverage
Up to 14sq/m per litre 
VOC level
Low 
Thinning
Water 
Touch dry
1-4 hours 
Recoatable
1-4 hours 
Suitable for...
Interior use 
Scrubbability
Scrubbable 
Colour
Magnolia 
Colour type
Ready mixed 
Finish
Matt 
Cleanup
Water & Detergent 
Base
Water 

* Colours on screen may vary from actual paint

Additional information

Preparation
Ensure surface to be painted is sound, clean, dry and free from grease. Remove all loose or defective paint. Seal absorbent surfaces with a solution of up to 1 part water to 4 parts Hardwearing Matt. Prime bare timber and metal surfaces with the appropriate Leyland Primer. Rub down sound previously gloss painted surfaces with fine waterproof abrasive paper and rinse thoroughly before applying a pre-coat of Leyland Trade Acrylic Primer Undercoat. Avoid the inhalation of dust. Wear a suitable face mask if dry sanding. Special precautions should be taken during preparation of pre-1960s paint surfaces over wood and metal as they may contain harmful lead.

Application
Stir well before use and apply by brush, roller or spray. When using a roller, use a medium pile synthetic type. Do not overfill the tray. Ensure roller is loaded evenly. If using a brush, load generously. Apply liberally and evenly; avoid overspreading. Under normal conditions, allow 4 hours before applying a second coat if required. Do not apply when air or surface temperature is below 10°C.

Coverage
1 litre will cover approximately 12 square metres, depending on the nature and porosity of the surface. Strong or contrasting colours may require additional coats. When using more than one can of a colour in the same room, intermix before use.