Bradite
CR27 Road Line Paint White 5L

BL041910F
A quick drying, universal road marking and line paint
CR27 Road Line Paint White
Share...

In detail

A quick drying, universal road marking and line paint suitable for application on asphalt concrete and brick, on roads, runways, car parks and sports facilities. Based on a combined alkyd and chlorinated rubber binder system. Excellent abrasion resistance, very quick drying. Resistant to water, oil and brine. No bleeding on asphalt or bitumen roads, can be used with a low slip additive.

2.5 square metres per litre at 220 microns DFT, 2.9 square metres per litre at 190 microns DFT (25-29 metres/litre of 10cm width continuous line) (loss factors will apply on practice)

Size
5L 
Application Methods
Airless Spray, Brush, HVLP Spray, Roller
Coverage
Up to 5sq/m per litre 
VOC level
High 
Touch dry
Up to 1 hour 
Recoatable
1-4 hours 
Suitable for...
Interior and Exterior use 
Colour
White 
Colour type
Ready Mixed 
Finish
Eggshell 

* Colours on screen may vary from actual paint

Additional information

Bradite paints and coatings meet the highest quality and performance standards in the most demanding environments. To obtain satisfactory results you should ensure you know the best way to use the product. Free advice is available upon request from Bradite Paints and its distributors. General advice given below does not constitute a specification.

Preparation
Particular consideration should be paid to surface preparation, temperature and dryness of substrate. Surface should be dry, clean and to the specified standard.

Mixing
All materials should be mixed before use. Two-pack materials should be completely mixed before use. Do not mix old or pre-catalysed paints with new stock. The use of a mechanical mixer is always preferred. In the case of two-pack materials, take care not to mix more than can be used before the pot-life has expired.

Thinning
Only use those thinners recommended, not exceeding the proportions as specified. Thinners should only be added to two-pack products after mixing. Oil based decorative paints may be thinned with White Spirit. Decorative emulsion paints may be thinned with water.

Application
Paints and coatings may require thinning to ease application on absorbent substrates or to accommodate adverse climatic conditions. Do not apply coatings who the of the substrate is below 3°C above dew point, to avoid surface condensation affecting the coating as it dries. Be sure to follow guidance on drying times before overcoating and hand-over

Cleaning
Clean all equipment as soon as possible after finishing work, using the recommended cleaning thinners. Oil based decorative paints may be washed up with White Spirit. Decorate emulsion paints may be washed up with water.