Mathys
Metal Cladding Primer White 10L

BN37511610E
£232.55 inc. VAT
Trade customer? - log in to get your prices. close

Tell us where you are to check stock for Click & Collect:

Water based primer for use on all metal substrates including bare or blasted steel, galvanized metal and plastisol.
Metal Cladding Primer White
Share...

In detail

Mathys Metal Cladding Primer can be used on a wide variety of substrates like bare or blasted steel, galvanised steel, zinc, aluminium and steel protected by plastisol. 

Provides corrosion protection under industrial exposure conditions, if followed by a coat of Mathys® Metal Cladding Topcoat. 

  • Quick drying, can be overcoated after just 1 hour. 
  • Easy to apply. Excellent flow out. 
  • Can be applied on many metal surfaces. 
  • Water-based single pack product. 

Size
10L 
Application Methods
Airless Spray, Brush, Roller
Coverage
Up to 12.5sq/m per litre 
VOC level
Low 
Thinning
Water 
Touch dry
Under 1 hour 
Recoatable
1-4 hours 
Suitable for...
Exterior use 
Colour
White 
Colour type
White 
Finish
Matt 
Cleanup
Water & Detergent 
Base
Water 

* Colours on screen may vary from actual paint

Available colours

Mathys Metal Cladding Primer White is available in 1 colours from the Mathys Colour Cards.

    Browse colours

     
     
     
     
     
     
     
     
     
     
     
     
     
     
     
     
     
     
     
     
     
     
     
     

    Always ask your client to try their colour choice on the wall first. Colour cards and emulsion sample pots are available at your local Brewers or at designerpaint.com

    Additional information

    Surface Preparation

    Remove grease, oil and all other surface contaminants by alkaline or high pressure cleaning in combination with appropriate detergents. For optimum results remove rust, rust scale, mill scale and deteriorated coatings by abrasive blasting. If blasting is not possible remove loose rust and loose coatings by scraping and / or wire brushing. Zinc or aluminium corrosion products can be removed with Surfa-Etch 108 Etching Solution followed by rinsing with plenty of fresh water, or by brush-off blasting. Remove deteriorated coatings by scraping and wire brushing. Sand intact coatings to roughen the surface slightly. The surface must be clean and may be slightly damp during application.

    Application

    • To ensure homogeneity, coating materials should be thoroughly stirred prior to use.
    • Apply by brush, roller, airless spray or air atomised spray.

    Clean Up

    Clean immediately after use with water and soap.