HARD HAT 1078 Heat Resistant Coating can be applied on new, bright or shot-blasted steel or well pre-treated coated surfaces such as barbecues.
Intended for small maintenance jobs and repairs.
Provides heat resistance for continuous temperatures up to 650.
- Up to 10sq/m per litre
- VOC level
- Touch dry
- Up to 1 hour
- Over 24 hours
- Colour type
* Colours on screen may vary from actual paint
Hard Hat® heat resistant coating can be applied to new, bright or shot-blasted steel or well pre-treated coated
surfaces such as barbecues, boiler fittings, hot air cannons, exhausts, etc. Hard Hat® heat resistant coating is intended for small maintenance jobs and repairs. Hard Hat® heat resistant coating provides protection up to a dry heat of 750°C (short-term peak load) for applications indoors or in a sheltered outdoor environment.
Surface Preparation: Clear of grease, oil, dirt, loose rust, loose coatings and any other contamination using suitable agents. Sand intact, old paintwork so as to obtain a good key. The surface must be clean and dry during application.
Mixing and Thinning: The coatings must be stirred vigorously before use until they are thoroughly mixed. Do not thin Hard Hat® heat resistant coating.
Application: Only apply if the air and surface temperatures are between 5 and 35°C and the relative humidity is less than 85%. The temperature of the coated surface must be at least 3°C above the dew point.
Theoretical Coverage: 10-12m² per litre at 35-40 μm dry.
Drying Times: (at 20°C/50% RH).
Tack free: 2 hours.
To handle: 8 hours.
Overcoatable: after 24 hours.
Fully cured: 24 hours after the minimum service temp of 150°C is reached.
Gradually heat the coating to 150°C (max. 50°C/ hour).
Clean Up: with RUST-OLEUM® thinners 7301.