Rust-Oleum Industrial
Super Adhesive 3333.5 + Activator 5L

£175.85 inc. VAT
Trade customer? - log in to get your prices. close

Tell us where you are to check stock for Click & Collect:

Two pack water based epoxy adhesion primer, for power floated concrete.
Super Adhesive 3333.5 + Activator

In detail

Water-based primer for use on smooth non-porous floors, like power-floated concrete and tiles. 

Water-based no odour and safe to use, can be overcoat with any Rust-Oleum or Mathys epoxy or polyurethane coatings.

Touch dry
5-8 hours 
12-24 hours 

Additional information

Waterdilutable Adhesion Primer

The waterdilutable adhesion primer SUPER ADHESIVE 3333 is specially designed for use on very smooth surface a.o. glass, ceramic tiles, fiber-glass and power floated glazed concrete. It can be recoated with almost all kinds of topcoat and is lead and chromate free.

Surface Preparation

Remove grease, oil and other surface contamination by alkaline cleaning or (high pressure) steam cleaning. New concrete should be allowed to dry and cure prior to coating. After cleaning the surface may still be slightly damp when the coating is applied.

Mixing and thinning

Mix activator into homogeneous base material. Thinning with water Brush or roller: up to 10 vol.%

Air-atomized spray: 10-20 vol.%


The best results are obtained when using a roller. Recommended dry film-thickness; 15µm. Potlife 2 hours. Practical coverage approx. 41m² at 15µm dry. Application temperature between 10-35°C and rel. humidity below 85%.

Drying times

(at 20°C and 50% rel. humidity) to touch: 6 hours. to handle: 8 hours.

to recoat: 16 hours. full hardness: 8 days

Clean up

Immediately after use with water and soap.