Quick Drying Flexarb Opaque Satin Brown 5L
In detail
- Size
- 5L
- Application Methods
- Brush
- Coverage
- Up to 20sq/m per litre
- VOC level
- Medium
- Thinning
- Water
- Touch dry
- 1-2 hours
- Recoatable
- 16 hours
- Suitable for...
- Exterior use
- Scrubbability
- Washable
- Colour
- Brown
- Finish
- Satin
- Cleanup
- Water & Detergent
Data sheets
Additional information
Surface Preparation
Timber surfaces must be suitably prepared, clean, sound and dry. Any grey denatured exposed timber surfaces must be mechanically sanded back to clean, bright timber. The moisture content should not exceed 18% prior to coating. Resinous deposits should be removed. Degrease any exposed bare timber surface by wiping with a cloth dampened with methylated spirits.
Treat knots with two thin coats of fresh knotting. Fillers specifically designed for use with timber should be used for making good any minor surface defects, imperfections and open joints etc. General or All Purpose fillers are not suitable.
Only use non – ferrous screws, nails and fixings.
Application
Should be applied in a full flowing coat ensuring all surfaces and end grains are fully coated.
For best results use a good quality brush specifically designed for use for the application of water borne products.
Pay special attention to end grain, tops and bottoms of doors, and undersides of cills. Following surface preparation in accordance with the manufacturers recommendations, finish with two full coats allowing a minimum of 16 hours drying between coats.
Clearing Up
Clean brushes and equipment with warm, soapy water and rinse with clean water immediately after use. If spilled remove immediately while still wet, using clean water.