Epimac Floor Coating Mid Grey (Ready Mixed) 5L
In detail
Crown Trade Epimac Floor Coating is a high VOC content mid sheen finish. A washable product that is applied by brush and suitable for interior use.
Under normal drying surface dry in 4 hours and recoatable after 16 hours. Allow for adequate ventilation during the drying period. Recoat within 48 hours.
Do not apply when air or substrate temperatures are likely to fall below 8°C or when the relative humidity is above 80% during application or the drying period.
- Size
- 5L
- Application Methods
- Brush, Roller
- Coverage
- Up to 15sq/m per litre
- VOC level
- High
- Thinning
- Not Recommended
- Touch dry
- 1-4 hours
- Recoatable
- 12-24 hours
- Scrubbability
- Washable
- Colour
- Mid Grey
- Finish
- Satin
- Cleanup
- Brush cleaner or White spirit
Data sheets
Additional information
Crown Trade Epimac Floor Coating is an Epoxy Ester based floor coating which produces a satin finish which is resistant to abrasion and spillages of most dilute chemical solutions. Recommended for interior use on dry and correctly prepared coated and uncoated concrete, stone, metal and wood floor surfaces. Not recommended for areas subjected to standing water or smooth power floated concrete without pre-etching / blasting.
Preparation
Ensure all surfaces are sound, dry, clean, and free from dirt, oil, grease, wax, polish or other contamination. Remove all loose or flaking material back to a firm sound edge. An effective damp proof membrane must be present beneath concrete and masonry floors. New concrete must be left at least six months to dry out in depth before painting.
On bare concrete remove surface latence using a proprietary cement cleaner to manufacturer's instructions. Thoroughly abrade previously painted surfaces, wash with a warm detergent solution, rinse with clean water to remove all residues and allow to dry. Avoid the inhalation of dust. Wear a suitable face mask if dry sanding.
Application
- Stir well before use.
- Always intermix packs for colour consistency.
- Please check for colour accuracy prior to application.
- Apply by brush or roller (short — medium pile only). Do not apply thickly.
- Do not apply to ASPHALT or BITUMEN based surfaces.
- Ensure adequate ventilation.
- Do not apply in temperatures below 8°C or in high humidity.
- Do not use industrial cleaners or polish on the coated floor within seven days of application.