Store locator
Favourites
Account
Heavy Duty Floor Varnish Dead Flat 4L
Share
-
Email
-
Facebook
-
Pinterest
-
Fast drying, heat and water resistant protection for interior floors.
Free next day delivery
- Size
- 4L
- Barcode
- 729870009844
- Application Methods
- Brush, Roller, Spray
- Coverage
- Up to 20sq/m per litre
- VOC level
- Low
- Thinning
- Water
- Touch dry
- 1-4 hours
- Recoatable
- 1-4 hours
- Scrubbability
- Washable
- Colour
- Clear
- Finish
- Dead Flat
- Cleanup
- Water & Detergent
Data Sheets
-
Health and Safety Data Sheet The Health and Safety data sheet for Heavy Duty Floor Varnish Dead Flat 4L -
Product Data Sheet The Product data sheet for Heavy Duty Floor Varnish Dead Flat 4L
Additional Information
Surface Preparation
Ensure the surface to be coated is clean and free from grease, wax or polish. White spirit or sugar soap should be used as cleaning agents. Sugar soap should be rinsed off well with clean water and allowed to dry. If water has been used on bare wood this would raise the grain. If water has been used on bare wood this would raise the grain. The surface then needs to be sanded and vacuumed before coating.
Wooden floors should be sanded with an industrial sander to ensure a smooth finish.Newly painted wood should first be sanded to provide a key. Natural Floor Varnish should not be applied over uncured oil base paint as this may cause discoloration.
Older painted wood, where the paint itself may fail, should be stripped using a hot air gun or a chemical paint stripper, sanded and cleaned prior to coating.When applied over emulsion/latex paint, it is possible that Natural Floor Varnish can draw certain stains through the paint which were not otherwise be visible. In this case a stain sealer should be used.
Application
- Can be applied by brush, spray or roller.
- Porous surfaces should be primed with Natural Floor Varnish diluted 10% with water, prior to applying a further 2 or 3 coats.
- On wooden floors, light sanding in between coats may be necessary, if there is any raising of the grain.
- Allow 2 hours in between coats and 16 hours after final coat before full use.
- Do not use in temperatures below 5°C / 40°F or in very high humidity. Lower temperatures will slow the final cure time.
Clean Up
Any equipment used can be cleaned using soap and water before the clear coat dries. Wipe any excess off surfaces with a damp cloth. Any dried deposits will need a paint stripper to remove them.
