Cuprinol
Garden Shades Matt (Ready Mixed) 2.5L

HA159302J
Semi-transparent wood treatment for exterior wood. Available in a range of colours.
Garden Shades Matt (Ready Mixed)
Share...

In detail

Cuprinol Garden Shades is a semi-transparent matt finish treatment for exterior wood, specifically sheds and fences. Can be applied to both smooth and rough sawn timber by brush or spray. Special pigments ensure a rich colour and allow the natural texture of the woodgrain to shine through.

For spray application, use of either the Cuprinol Fence Spray or Cuprinol Power Sprayer are recommended. Recoatable in 8 hours with coverage up to 12sq/m per litre on smooth timber and 5sq/m per litre on rough sawn timber.

Size
2.5L 
Application Methods
Brush, Spray
Coverage
Up to 12sq/m per litre 
VOC level
Low 
Thinning
Water 
Touch dry
1-4 hours 
Recoatable
4-8 hours 
Suitable for...
Exterior use 
Scrubbability
Washable 
Lifespan
Up to 5 years 
Colour
Barleywood 
Colour type
Ready Mixed 
Finish
Matt 
Cleanup
Water & Detergent 

Available colours

Cuprinol Garden Shades Matt (Ready Mixed) is available in 17 colours from the Cuprinol Colour Cards.

    Browse colours

    Always ask your client to try their colour choice on the wall first. Colour cards and emulsion sample pots are available at your local Brewers or at designerpaint.com

    Additional information

    Cuprinol Garden Shades has been specially developed to colour and protect sheds, fences and other garden wood. Its special pigments ensure a rich colour and allow the natural texture of the woodgrain to shine through. It can also be applied on terracotta, brick and stone, bringing out beautiful rich colour into the garden.

    Preparation

    Read the Health, Safety and Environment information opposite. All surfaces should be clean (free from dirt, algae, grease and flaking paint) and dry. Remove any algae, lichen or fungi using an appropriate fungicidal wash or clearner designed for the job.

    • Test a small area first for colour and adhesion: Colour the final colour will depend upon the type of surface, previous treatment and number of coats applied. If using more than one can it is advisable to mix them together in a container or finish in a corner before starting a new can. Adhesion: if adhesion is inadequate on previously coated surfaces, lightly sand before application.
    • Untreated wood: should be pre-treated prior to adhesion test with an appropriate wood preserver to prevent rot and decay.
    • Previously coated wood: loose, flaking paint should be stripped back to bare wood.

    Application by brush

    • Stir thoroughly before and during use.

    Application by spray (for wood only)

    • Refer to the Cuprinol sprayer instructions leaflet before use.
    • Stir thoroughly before pouring contents into a Cuprinol sprayer. Overspraying surrounding areas can be minimized by avoiding spraying in windy conditions and by using cardboard or plastic as a shield. Any overspray should be cleaned up immediately (whilst still wet) with water and household detergent.

    Minimum of two coats required. Subsequent coats MUST be applied on the same day no longer than 8 hours apart. If not possible, lightly sand down surfaces before recoat to ensure adhesion.