Jontex High Build Masonry Brilliant White 10L
AF120005E
Trade customer? - log in to get your prices. close
High build, heavily textured, matt finish for exterior use. Offering long term protection to badly weathered masonry and other surfaces.
Share...
In detail
Johnstone's Trade Jontex High Build Masonry is a high build, heavily textured, one coat finish formulated for exterior use on cement rendering, rough cast, brick, concrete, cement sheeting and suitably prepared plywood panels.
It provides heavy duty, flexible, long term protection which covers small cracks and is suitable for application to badly weathered masonry surfaces with over 15 years long term protection.
Application is by brush with coverage between 0.5-1sq/m per litre.
Touch dry between 3-5 hours and recoatable after 12 hours.
- Size
- 10L
- Application Methods
- Brush
- Coverage
- Up to 1sq/m per litre
- VOC level
- Low
- Thinning
- Water
- Touch dry
- 1-4 hours
- Recoatable
- 12-24 hours
- Suitable for...
- Exterior use
- Scrubbability
- Washable
- Lifespan
- Up to 15 years
- Colour
- Brilliant White
- Colour type
- White
- Finish
- Matt
- Cleanup
- Water & Detergent
- Base
- Water
* Colours on screen may vary from actual paint
Data sheets
Additional information
Preparation
All surfaces to be painted should be clean, dry and free from loose and flaking material. Repair large cracks and defective areas paying particular attention to those that may lead to moisture penetration. Treat fungal or algal growth with Fungicidal Wash as directed. Stabilise masonry surfaces of a highly porous or friable nature with Johnstone's Stormshield Stabilising Solution as directed. Rub down previously gloss painted surfaces with fine waterproof abrasive paper and rinse thoroughly. Wear a suitable face mask when creating dust. Prime bare plywood panels with Johnstone's Joncryl.
Application
Ensure sufficient material is available to complete each elevation or area. Maintain a working edge finishing only at design features, wall ends etc. Do not apply in temperatures below 10°C or when rain is imminent. Apply by:
1. Roller: A self-textured finish is achieved by using an open-structure foam roller. Keep the roller head fully loaded and apply a thick even film overlapping each stroke as necessary to produce a uniform texture.
2. Trowel: Apply a thick even film and texture with a sponge, comb, spatula or patterned roller.
3. Air Assisted Spray: With a hopper gun use a 6mm tip at 40 psi and produce an even coat via small circular movements. A priming coat of Johnstone's Stormshield Smooth or Textured Masonry in a similar colour will assist coverage when applying by spray.
Coverage
Johnstone's Jontex will cover approximately 0.5-1 square metre per litre depending on the nature and porosity of the surface being painted and the texture required.
Drying Time
Touch dry in 3-5 hours. Through dry in 48-72 hours.
After Use
Remove as much product as possible from application equipment before cleaning. Replace lid firmly. Clean equipment immediately after use with warm soapy water and rinse thoroughly. Some local authorities have special facilities for the disposal of waste coatings. Do not empty product into drains or watercourses.
General Information
Thinner: Clean water.
To avoid the risk of spillage, always store and transport in a secure upright position.
