Sandtex Trade
Fine Textured Matt Brilliant White 10L

AP0648001E
Premium quality, long lasting protection, fine textured matt finish for exterior use. Anti-carbonation coating.
Fine Textured Matt Brilliant White
Share...

In detail

Sandtex Trade Fine Textured Matt is a water-based, high opacity, fine textured finish for exterior masonry surfaces. Has an aggregate reinforced film with an anti-carbonation coating which prevents dirt build up on the surface and a fungicide to prevent mould growth. Provides 15 years of long lasting protection.

Can be applied to sound, previously coated render without thinning. On sound bare render, thin the first coat with water to manufacturer's recommendations. On chalky, friable surfaces, apply a stabilising solution as a priming coat, before applying a masonry coating.

Application is by brush or roller with coverage up to 7sq/m per litre. Touch dry between 1-2 hours and recoatable between 4-6 hours.

Size
10L 
Application Methods
Brush, Roller
Coverage
Up to 7sq/m per litre 
VOC level
Low 
Thinning
Water 
Touch dry
1-4 hours 
Recoatable
4-8 hours 
Suitable for...
Exterior use 
Scrubbability
Washable 
Lifespan
Up to 15 years 
Colour
Brilliant White 
Colour type
White 
Finish
Matt 
Cleanup
Water & Detergent 
Base
Water-Based 

* Colours on screen may vary from actual paint

Additional information

Surfaces

Sandtex Trade Fine Textured Matt can be applied to most sound exterior masonry surfaces including rendering (stucco), roughcast pebbledash and tyrolean; building blocks, concrete and facing bricks, exterior cement - based boards; surfaces previously painted with gloss and emulsion paints and other masonry and cement paints. Fletton, common or engineering bricks (regrades and facing) and bitumen coated surfaces are not suitable for decoration.

Preparation

For new or porous sound surfaces, apply 1 coat Sandex Trade Fine Textured Matt diluted 40% by volume with clean water, as a primer. Any faults in old surfaces must be rectified. Particular attention should be given to those which may lead to moisture penetration. Minor defects should be repaired with Sandiest Trade Exterior Easiplast. All surfaces must be clean, dry and free from any thing which may interfere with the adhesion of the materials to be applied. Sound gloss paint should be thoroughly abraded to provide a key. Avoid the inhalation of dust. Wear a suitable face mask if dry sanding. Loose or flaking material should be removed by scraping and brushing back to a sound, firm surface with a stiff bristle brush (not wire). Organic growth must be removed by scraping or brushing with a stiff bristle brush (not wire) and applying Sandex Trade Fungicide In accordance with the manufacturers instructions. Chalking, weathered and friable surfaces should be brushed down and treated with a liberal application of Sandtex Trade Stabilising Solution. Allow at least 16 hours before painting.

Application

  • Stir well before use.
  • Apply with a masonry paint brush, or exterior roller.
  • Not suitable for spray application.
  • For maximum durability apply two coats of Sandtex Trade Fine Textured Matt.
  • Do not apply when there is a risk of rain, frost or if the temperature will fail below 8°C during application and drying period.

Properties

Spreading Capacity Normally spreading rates will be between 3m² and 7m² per litre. On very textured surfaces e.g roughcast or pebbledash, spreading rates will greatly be reduced. Drying Time: Dry and re-coatable after 4-6 hours in normal drying conditions. In cold, damp conditions, drying times will be extended. Cleaning: Clean brushes and equipment with water Immediately after use.

Transportation and Storage

Ensure this pack is stored upright and secure at all times. Crown Paints Ltd. cannot accept liability for damage caused by spillage. Do not store below 5°C or above 40°C.