DP9 Floor-It Light Grey (Ready Mixed) 5L
In detail
Bradite Floor-It is a high performance floor coating which is formulated for use in light to medium traffic areas. Low odour acrylic floor paint which is ideal for use on factory walkways and general shopfloor, suitable for use on internal and external surfaces such as: wood, concrete, metal or asphalt surfaces as well as polyurethane, epoxy and chlorinate rubber coated floors.
- Size
- 5L
- Application Methods
- Brush, Roller, Spray
- Coverage
- Up to 12sq/m per litre
- Thinning
- Water
- Touch dry
- Up to 1 hour
- Recoatable
- 1-4 hours
- Suitable for...
- Interior and Exterior use
- Colour
- Light Grey
- Colour type
- Ready Mixed
- Finish
- Semi-Gloss
- Cleanup
- Water & Detergent
- Base
- Water-Based
* Colours on screen may vary from actual paint
Data sheets
Additional information
DP9 is a high performance ambient cross-linking water based acrylic floor paint, Suitable for use over interior/exterior bare or previously painted suitable prepared concrete, wood, steel, tarmac asphalt floors requiring an economical, hard wearing, flexible coating with good chemical and excellent water resistance.
Preparation
Substrates should be dust free and completely dry before coating. When painting concrete it is vital to ensure that the substrate is completely dry and free of laitance. If the concrete is loose, chipping or has concrete dust present, the coating will not perform properly unless all loose material and dust is removed and damaged areas are repaired. Powder Coated, shiny or unpainted non porous concrete floors should be thoroughly vacuum blast cleaned to a roughness profile of 30-50 microns, or acid etched using Bradite TA37. Please consult the product data sheet for more details.
High pressure water cleaning should be utilised to remove all loose and flaking paint and contamination back to a sound substrate. Bradite TD39 industrial strength detergent should be used if necessary to remove all grease and oil.
Intact areas of existing coatings should be roughened by abrasive manual or disc rubbing and feathered back to a sound coating edge. Cracks and pits should be filled using a suitable screed or mortar before painting.
Painting System
For application on concrete, wood or other absorbent substrates, the first coat should be thinned 5-10% water to allow penetration into the substrate.
- 1st coat Bradite Floor-It DP9 (thinned)
- 2nd coat Bradite Floor-It DP9
- 3rd coat Bradite Floor-It DP9
For maintenance painting the 1st coat will be a touch up to bare areas only.
Application
- Brush and Roller - supplied ready for use. Thin with 0-5% water if required.
- Conventional Air Spraying - Thin with 5-15% water as required, +tip size - 2.0mm, tip pressure 60psi (0.4MPa) approximtely
- Airless Spraying - Thin with 0-10% water as required, tip size - 18 thou (0.46mm) approximately, tip pressure - 2100psi (15MPa_ approximately.
){kind=link}