Problem Solver - Hardwoods
Problem
Hardwoods are mainly from broad leaf trees, slow grown and often dense, they can have colour variation and often are highly resinous. Moisture content should not exceed 18%.
Stages
Stage 1 - Preparation
Ensure surface is sound dry and clean
If any mould or mildew is apparent, treat with a suitable fungicidal solution, rinse again with clean water and allow to dry.
Abrade with 100 grit abrasive paper to remove any loose or flaking areas and to create a key
If surface requires filling where repairs have been carried out use a two- part filler suiatble for timber
Sand the surface using a fine wet and dry paper. Resinous timber apply a hot air gun to bring excess resin to the surface then wipe with Methylated Spirit frequently changing the clothes (Take care in disposing of used cloths)
Stage 2 - Basecoat
Apply a suitable primer
Apply a suitable undercoat
Stage 3 - Topcoat
Apply a suitable topcoat
Problem
Hardwoods are mainly from broad leaf trees, slow grown and often dense and can have colour variation and often are highly resinous moisture content should not exceed 18%
Stages
Stage 1 - Preparation
Ensure surface is sound dry and clean
If any mould or mildew is apparent, treat with a suitable fungicidal solution, rinse again with clean water and allow to dry.
Abrade with 100 grit abrasive paper to remove any loose or flaking areas and to create a key
If surface requires filling where repairs have been carried out use a two-part filler suitable for timber
Apply a hot air gun to bring excess resin to the surface then wipe with Methylated Spirit frequently changing the clothes (Take care in disposing of used clothes)
Stage 2 - Basecoat
Apply a suitable primer
Apply a suitable undercoat
Stage 3 - Topcoat
Apply a suitable topcoat